Money moves in and out of your Nolus account from the Account popover: click the wallet button in the top-right of the header, then Fund or Withdraw. You connect with a Solana wallet, either Solflare or Phantom.
Fund and withdraw on Solana
Open the Account popover, click Fund, pick the token, enter the amount, and approve the transaction in your Solana wallet. The picker lists every asset the Solana corridor carries, not only the ones you already hold: what you hold comes first, ordered by value, and the rest sit below it at zero. A balance shown as “-” is a figure the app has not read yet, not a zero. The app shows an Estimated Processing Time of about 6 seconds and keeps track of the transfer until it lands.
Withdraw works the same way in reverse, with one difference: the destination is locked to the wallet you connected and shown as a read-only field under Withdraw To. Funds always return to the wallet they came from, so there is no address to type and none to mistype.
Both forms open without a wallet, so you can look through them before you connect. Until a wallet is attached the destination field reads “connect wallet to continue”, and clicking Fund or Withdraw opens the Select Wallet picker instead of submitting.
Assets move between your Nolus account and Solana over the protocol’s transfer channel, in both directions, from these two forms.
Before your first Solana transfer
You pay the Solana network fee yourself, in SOL. If your wallet cannot cover it, the form stops you with “Add SOL to your Solana wallet to cover the network fee” before anything is signed. The same message can also appear after you approve in your wallet, when the send itself fails on the fee: the funding did not go through and the tokens never left your wallet.
Funding SOL itself is capped so enough is left behind to pay that fee, which is why the amount filled by the balance line can sit under the balance printed above it.
If your wallet has never held the token, there is nothing to set up. The one-time account for it on Solana is created when the transfer arrives, and its cost is covered by the protocol.
Funding carries a deadline of roughly 23 hours. A transfer not delivered by then is refunded to you instead of hanging.
Do not fund from a wallet backed by a Ledger device yet. Such an account can send funds in, but it cannot yet sign the Nolus-side transactions that move them again, so anything funded from it stays in the Nolus account until Ledger signing ships. Use a software wallet for Nolus.
Following a transfer
A Solana Fund or Withdraw shows in Activities as a Transfer row with the amount and the address the funds came from or went to. While it is on its way the row reads In Progress, and it clears as soon as the network confirms the transfer rather than on a refresh cycle; your balances update at the same moment. The app posts a short notice reading “Transfer completed” when it finishes, or “The funding did not complete” or “The withdrawal did not complete” if it did not. Tracking survives a page reload, so you can close the tab and come back. Transaction hashes you copy from the app are Nolus hashes.
Sending assets to another wallet
The app does not support direct wallet-to-wallet transfers. Fund and Withdraw move assets between your own wallet and your own Nolus account; sending tokens to someone else’s address is done from your wallet.
To do that, open your connected wallet, select the token you want to send, enter the recipient’s address, set the amount, and confirm the transaction.